Programming Chasers - Renkforce 1359969 Mode D'emploi

• Proceed accordingly with the other effect lights to be changed for this scene by selecting them with the
SCANNERS (1) buttons and changing the respective channel fader (18) or the joystick PAN/TILT (13) set-
tings.
• Press the MIDI/REC button (5).
• Press the SCENES (2) button for the scene changed to save the change.
• Proceed accordingly with any other scenes to be changed.
• Press and hold the PROGRAM/PAUSE button (3) to leave the programming mode again.
d) Programming chasers
A chaser is a sequence of programmes and/or scenes to be played in sequence.
This DMX controller can save up to 6 chasers with up to 240 steps each.
Saving individual scenes for a chaser
• Press and hold the PROGRAM/PAUSE button (3) until the respective LED flashes.
• Select the desired number for the chaser to be saved as with the CHASE 1-6 (12) buttons. The chaser
number is indicated on the display (6).
• Select the desired programme in which the desired scene is located with the button BANK (9).
• Select the desired scene with the SCENES buttons (2).
• Press the MIDI/REC button (5) to save this step.
• Select the next scene as described above using the buttons BANK (9) and SCENES (2).
• Push the MIDI/REC button (5) again to save the second step.
• Repeat this scene storage procedure until all desired scenes have been saved. You can save up to
240 scenes per chaser.
• Press and hold the PROGRAM/PAUSE button (3) to save the chaser.
• The DMX controller is now in blackout mode again.
42