BORETTI BVW88 Notice D'utilisation page 33

2. Make sure that the appliance is in setting
mode.
3. Press one of two programme selection
buttons again and again until the digital
display shows number corresponding to
the required programme. Refer to the
chapter 'Washing programmes'.
4. Close the door.
– The washing programme starts.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme
Important! Set the half-load option before
the start of a washing programme. You
cannot set the option when a washing
programme operates. If it is necessary to set
the half-load option, cancel the washing
programme.
Warning! Only interrupt or cancel a
washing programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point
of interruption.
Cancelling a washing programme
1. Press and hold the Cancel button until the
digital display shows two horizontal lines.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent
before you set a new washing programme.
Setting and starting a washing
programme with delay start
1. Switch on the appliance.
All manuals and user guides at all-guides.com
2. Make sure that the appliance is in setting
mode.
3. Set a washing programme.
4. Press the delay start button until the dis-
play shows the necessary delay start of
the washing programme.
– The delay start indicator light comes
on.
5. Close the door.
– The countdown of the delay start
starts.
– The countdown of the delay start de-
creases with steps of 1 hour.
– When the countdown is completed,
the washing programme starts auto-
matically.
Do not open the door during the count-
down to prevent interruption of the
countdown. When you close the door
again, the countdown continues from
the point of interruption.
Cancelling a delay start
1. Press and hold the Cancel button until the
digital display shows two horizontal lines.
– When you cancel a delay start, you also
cancel the washing programme.
2. Set a new washing programme.
End of the washing programme
• The appliance stops automatically.
• The audible signal for the end of the pro-
gramme operates.
1. Open the door.
– The digital display shows 0.
– The end-of-programme indicator light
comes on.
2. Switch off the appliance.
3. For better drying results, keep the door
ajar for some minutes before you remove
the dishes.
Let the dishes cool down before you remove
them from the appliance. Hot dishes are
easily damaged.
33