BORETTI BVW88 Notice D'utilisation page 25

• Decrease the detergent dosage when you
use the half-load option.
• Press the half-load button to set the op-
tion.
– The half-load indicator light comes on,
when the half-load option is selectable.
With the half-load button pressed the
time duration and the consumption of
water and energy are reduced.
Delay start button
Use the delay start button to delay the start
of the washing programme with an interval
between 1 and 19 hours. Refer to the chapter
'Setting and starting a washing programme'.
Multitab button
Press this button to activate/deactivate the
multitab function. Refer to the chapter 'Mul-
titab function'.
Cancel button
With this button you can cancel a washing
programme or a delay start. Refer to 'Setting
and starting a washing programme'.
Function buttons
Use the function buttons for these opera-
tions:
• To set the water softener. Refer to the
chapter 'Setting the water softener'.
• To deactivate/activate the audible signals.
Refer to the section 'Audible signals'.
• To deactivate/activate the rinse aid dis-
penser, when multitab function is active.
Refer to the chapter 'Multitab function'.
Setting mode
The appliance must be in setting mode for
these operations:
• To set a washing programme.
• To set the water softener level.
• To deactivate/activate the audible signals.
• To deactivate/activate the rinse aid dis-
penser.
Press the on/off button. The appliance is in
setting mode when:
– The digital display shows two horizontal
bars.
All manuals and user guides at all-guides.com
Press the on/off button. The appliance is not
in setting mode when:
– The digital display shows the minutes of
the programme duration.
– A washing programme is set. It is neces-
sary to cancel the programme to go back
to the setting mode. Refer to the chapter
'Setting and starting a washing pro-
gramme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water
softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at
the factory.
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Release function buttons A and B.
5. Press the function button C.
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C
flashes.
– The digital display shows the setting.
The audible signals are activated.
6. Press the function button C again.
– The digital display shows the new set-
ting.
The audible signals are deactivated.
7. Switch off the appliance to save the op-
eration.
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the digital
display shows necessary setting.
Audible signals deactiva-
ted
Audible signals activated
25