Technical Data; Installation; Water Connection - BORETTI BVW88 Notice D'utilisation

38
Limescales particles on the
dishes
The dishes are wet and dull
There are streaks, milky spots
or a bluish coating on glasses
and dishes
Dry water drop signs on
glasses and dishes

Technical data

Dimensions
Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity

Installation

Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Important! Obey the instructions in the
enclosed template to:
• Build-in the appliance.
• Install the furniture panel.
• Connect to the water supply and drain.
Install the appliance under a counter (kitchen
worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap and
a drain.
For the venting of the dishwasher only water
fill, water drain and power supply cable open-
ings are necessary.
The dishwasher has adjustable feet to allow
the adjustment of the height.

Water connection

Water inlet hose
Connected the appliance to a hot (max. 60°)
or cold water supply.
All manuals and user guides at all-guides.com
The cleaning results are not satisfactory
• The salt container is empty.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
• No rinse aid has been used.
• The rinse aid dispenser is empty.
• Decrease the rinse aid dosage.
• Increase rinse aid dosage.
• The detergent can be the cause.
Width cm
Height cm
Depth cm
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Minimum
Maximum
Place settings
Make sure that the water inlet hose, the drain
hose and the supply cable are not kinked or
squashed, when you insert the machine.
Attaching the appliance to the adjacent
units
Make sure that the counter below which you
attach the appliance is a safe structure (ad-
jacent kitchen units, cabinets, wall).
Adjusting the level of the appliance
Make sure that the appliance is level to close
and seal the door correctly. If the level of the
appliance is correct, the door does not catch
on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the ad-
justable feet until the appliance is level.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
59,6
81,8 - 87,8
55
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
12