Motorola Solutions DTR Serie Mode D'emploi page 12

Status
Standby**
Battery Level Status
* Normally, re-positioning the battery pack will correct this issue.
** Battery temperature is too warm or too cold or wrong power voltage is being used.
If there is NO LED indication:
1. Check that the radio, or stand-alone battery, is inserted correctly.
2. Ensure the power supply is plugged into an appropriate AC outlet.
(for DTR Single Unit Charger (SUC) Tray only).
3. Ensure the USB connector of the power supply is plugged securely
into the charger socket (for DTR Single Unit Charger (SUC) Tray
only).
4. Ensure the power cord is plugged securely into the charger socket
with an appropriate AC outlet and there is power to the outlet (for
DTR 6-Pocket Multi-Unit Charger Tray only)
5. Confirm that the battery used with the radio is Motorola Solutions
authorized batteries listed in Table 1.
Mounting DTR 6-Pocket Multi-Unit Charger
1. Mounted the charger to wall using the appropriate mounting
hardware required for the type of wall material fixture it is being
mounted to.
Note: It is recommended to use #6x1 inch flat head tapping screw on
wood stud and solid-flat concrete or brick wall.
Charger LED Indicator (Continue)
Table 6:
LED Status
Amber slow flash
Flash red 1 time
Flash amber 2 times
Flash green 3 times
10
Comments
Battery low
Battery medium
Battery high