Connecting An Electric Latch Or Lock; Using The Videophone; Controls On The Videophone; Controls On The Video Camera - Extel LENA 11.3 Guide D'installation Et D'utilisation

b. Connecting an electric latch or lock
Connect the lock directly to terminals 5 and 6 on the back of the video camera (no colour coding).
Note that this function is only available when the screen is displaying the video from outside.
Important: The strike plate or electric lock that you are about to install must have a mechanical memory, like all
EXTEL products. For wiring, see the label on the back of the camera.
c. Connecting a gate motor
Directly connect to contacts 3 and 4 on the back of the camera. The camera delivers a "dry" contact with no
current, to be connected to the "push button" control of your automatic opener.
Note that this function is only available when the screen is displaying the video from outside.
6. USING
a. Using the videophone
• Pressing the button on the street unit triggers an audible alarm and switches on the monitor for approximately
30 seconds. When the visitor has been identified, press the
Note: The button only needs pressing once to communicate with the street unit.
• When the conversation is finished, wait for the end of the time-out (approximately 2 min) or press the
button to turn the monitor off.
• Prolonging the image :
To prolong the image a further 60 seconds, press the
• Activating a latch:
The latch or lock is activated when the
• Activating an automatic control:
To activate an automatic control, press the
It should be noted that the opening functions are only valid when the screen is switched on. The
image disappears briefly when the command is transmitted.
b. Controls on the videophone
4 controls are located on the side of the monitor:
• Melody select and activation/de-activation of the luminous outline (1. Ding Dong/luminous outline on * - 2. S.A.C/
luminous outlines off) (12)
* the LEDs only light up according to the level of darkness of the room and if the monitor is in sleep mode
• Melody volume control (10)
• Brightness control (9)
• Colour control (8)
c. Controls on the video camera
If when you are installing the monitor and the outdoor station in their definitive location you find that the lens of
the video camera is misaligned, you can correct this mispositioning using the adjustment holes located at the back
of the outdoor station. Caution, you can only correct the height by a few centimetres.

7. TECHNICAL SPECIFICATIONS

a. Monitor
(MN LENA 18.3)
• Reference : 812218
• Power supply: 17 V
• Power consumption: 6,8 W
• Screen: 7" - 18 cm
• Resolution : 480 x 234
• Measurements (mm): 115 x 210 x 21
GB4
(fig. 6)
(fig. 6)
button is pressed.
button.
(fig.2)
(fig.3)
a. Monitor
• Reference : 812211
• Power supply: 17 V
• Power consumption: 4,25 W
• Screen: 4,3" - 11 cm
• Resolution : 320 x 240
• Measurements (mm): 185 x 125 x 20
CFI EXTEL LENA 11 / LENA 18
.3
http://www.bakonline.net/
button to talk.
button.
(MN LENA 11.3)
- 01/2013
.3