CAPITAL SPORTS 10033087 Mode D'emploi page 29

Belt and electric running special lubricating oil
The board and belt of this electric treadmill have been lubricated in advance.
The friction force between the belt and the board has a great influence on the
service life and performance of the electric treadmill, so it must be lubricated
regularly. We suggest regular inspection of the board. Please contact our
customer service center if the panel is damaged.
We propose to apply the lubricating oil between the belt and the board of the
electric treadmill according to the following schedule:
• Occasional users (less than 3 hours per week): once a month;
• Regular users (more than 7 hours per week): once every half a month.
To better maintain your electric treadmill and extend the life of the machine, it
is recommended that you turn off the power supply after 2 hours and then use
it after 10 minutes of rest.
If the belt is too loose, there will be skidding during running. If too tight, too
tight may reduce the performance of the motor and make the roller, running
wear more wear. When the belt is relaxed and comfortable, you can lift the
walking band from the board about 50 to 75mm with your hand.
Adjust the belt
• Place the electric treadmill on flat ground.
• Make the electric treadmill run at about 3 to 5 kilometers per hour.
• If the belt inclines to the right, rotate the adjusting bolt on the right by
1/2 circle clockwise, and then rotate the left adjusting bolt by 1/2 ring in
counterclockwise direction (Figure A).
• If the belt is tilted to the left, rotate the left adjusting bolt clockwise by 1/2
circle clockwise, and then rotate the adjusting bolt on the right by a half
circle counterclockwise (Figure B).
A B
EN
29