AIRFORCE Gabrielle Prescriptions De Montage Et Mode D'emploi page 24

I GB
RF CODE RC433 RGB/CCT/DIM remote control (full touch)
Tips:
1. Without any operation for more than 6 seconds, the touch remote will go in stand-by, please
remote controller to wake it up before the next using.
2. The receiver is supplied from the factory with the same universal code for all;
Only if a specific match with a specific receiver is needed, then the receiver and the remote control have to be
matched by following the below instructions.
Matching code operation (on demand)
When in the same installation more remote controls and receivers have to work independently, they have to be
matched one by one according to the below instructions:
1. Step 1: Press key "MODE" and keep it pressed till the controller is ON; the load of the LEDs will be
positioned on 50% of the brightness.
2. Step 2: keep pressed the "PAUSE" key for RGB, or the "ON" key for CCT/DIM for 3 times within 5 seconds
after step 1 and the brightness of the LEDs will reduce to 25% and 10%.
3. If the code learning has been successful, the receiver will only be controlled by the matched remote.
4. If not, please repeat the operation from step 1 to 2.
Clear code operation – return to the original factory programming
After this operation, the remote control will command all the receivers again
1. Step 1: Press the key "MODE" and keep it pressed till the controller is ON; the load of the LEDs will be
positioned on 50% of their brightness.
Step 2: keep pressed "Speed/Brightness
2.
brightness of the LEDs will reduce to 25% and 10%.
3. If the code clearing has been successful, the LEDs will turn back to their status before power has been
taken off, and the receiver can be controlled by any remote control.
4. If not, please repeat the operation from step 1 to 2.
AVVERTENZE OPERATION
-
" key for 3 times within 5 seconds after step 1 and the
24
SHAKE the