Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Configuration
(Standalone)
Sound-Active
Mode
Automatic Mode
Display Timeout
Test Mode
Factory Reset
Swarm™ 4 FX User Manual Rev. 1
Set the product in one of the Standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any Standalone mode (Static, Automatic, or
Sound) to a DMX string connected to a DMX controller. Products in Standalone mode may
transmit DMX signals that could interfere with the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
1.
Press <MENU> repeatedly until Sou- shows on the display.
2.
Press <ENTER> and Sou0–Sou9 will show on the display.
3.
Use <UP> or <DOWN> to select the desired Sound-Active program.
4.
Press <ENTER>.
5.
Turn the music on and adjust the sound sensitivity knob until the product starts responding to
the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
The product will blackout when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
To enable the Automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until Aut- shows on the display.
2.
Press <ENTER> and Aut0–Aut9 will show on the display.
3.
Use <UP> or <DOWN> to select the desired Auto program.
4.
Press <ENTER> and S.01–S.99 will show on the display.
5.
Use <UP> or <DOWN> to adjust the program speed.
6.
Press <ENTER>.
To enable or disable the Display Timeout, do the following:
1.
Press <MENU> repeatedly until SYS shows on the display.
2.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
3.
Use <UP> or <DOWN> to select LEdS.
4.
Press <ENTER> and on or oFF will show on the display.
5.
Use <UP> or <DOWN> to select the Display Timeout to be on or oFF.
6.
Press <ENTER>.
To run the Swarm™ 4 FX in Test mode, follow the instructions below:
1.
Press <MENU> repeatedly until SYS shows on the display.
2.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
3.
Use <UP> or <DOWN> to select tESt.
4.
Press <ENTER>.
To reset the Swarm™ 4 FX to factory defaults, do the following:
1.
Press <MENU> repeatedly until SYS shows on the display.
2.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
3.
Use <UP> or <DOWN> to select rESt.
4.
Press <ENTER>.
Page 23 of 80
Publicité
Table des Matières
