Configuration
Set the product in one of the Standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
(Standalone)
Never connect a product that is operating in any Standalone mode (Static, Automatic, or
Sound) to a DMX string connected to a DMX controller. Products in Standalone mode may
transmit DMX signals that could interfere with the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
Sound-Active
1.
Mode
2.
3.
4.
5.
The product will only respond to low frequencies of music (bass and drums).
The product will blackout when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
To enable the Automatic mode, follow the instructions below:
Automatic Mode
1.
2.
3.
4.
5.
6.
To enable or disable the Display Timeout, do the following:
Display Timeout
1.
2.
3.
4.
5.
6.
Test Mode
To run the Swarm™ 4 FX in Test mode, follow the instructions below:
1.
2.
3.
4.
To reset the Swarm™ 4 FX to factory defaults, do the following:
Factory Reset
1.
2.
3.
4.
Swarm™ 4 FX User Manual Rev. 1
All manuals and user guides at all-guides.com
Press <MENU> repeatedly until Sou- shows on the display.
Press <ENTER> and Sou0–Sou9 will show on the display.
Use <UP> or <DOWN> to select the desired Sound-Active program.
Press <ENTER>.
Turn the music on and adjust the sound sensitivity knob until the product starts responding to
the beat of the music.
Press <MENU> repeatedly until Aut- shows on the display.
Press <ENTER> and Aut0–Aut9 will show on the display.
Use <UP> or <DOWN> to select the desired Auto program.
Press <ENTER> and S.01–S.99 will show on the display.
Use <UP> or <DOWN> to adjust the program speed.
Press <ENTER>.
Press <MENU> repeatedly until SYS shows on the display.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
Use <UP> or <DOWN> to select LEdS.
Press <ENTER> and on or oFF will show on the display.
Use <UP> or <DOWN> to select the Display Timeout to be on or oFF.
Press <ENTER>.
Press <MENU> repeatedly until SYS shows on the display.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
Use <UP> or <DOWN> to select tESt.
Press <ENTER>.
Press <MENU> repeatedly until SYS shows on the display.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
Use <UP> or <DOWN> to select rESt.
Press <ENTER>.
Page 23 of 80