Anchoring The Tent - Partyspace BONBO PAGODA Mode D'emploi

ANCHORING THE TENT

Soft ground:
1. Place a peg in an opening of each base plate.
2. Attach the S-hook of the tension strap to the loop of the
corner piece (Figure 12).
3. Place a peg in the ground through the snap hook of the
ratchet in the length of each corner approximately two
metres f rom the pole. You can also use the snap hook
to attach the tension strap to (a concrete block with) an
eye bolt.
4. Connect the ratchet with the tension strap and place
the tent under tension evenly in all four corners.
Tip: To anchor the tent more f irmly, you can always use
heavier anchoring.
Hard ground
1. Attach the S-hook of the tension strap to the loop of the corner piece (Figure 12).
2. Attach the snap hook of the ratchet to an anchoring point.
3. Connect the ratchet with the tension strap and place the tent under tension evenly in all
four corners.
PAGODA MANUAL (ALUMINIUM POLES)
9
Figure 12
EN
Figure 11
Figure 13