Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
ASSEMBLY
TIP: Use a groundsheet to prevent the tent canvas f rom getting dirty during assembly.
1.
Lay the four corner pieces approximately the correct distance f rom each other.
2. Lay all the horizontal tubes between the corner pieces and connect them together using
the connector piece. See f igure 1b.
Pay attention - The horizontal tubes for the pagoda tent of 3 x 3 m are made in one piece.
3.
Fit the connected tubes into the corner pieces. Ensure that the keder groove is facing
down.
4. Connect the corners of the roof f rame diagonally with each other using the steel cables.
Tension the cables manually and evenly using the turnbuckles. Ensure that the f rame is
not skewed and ensure that the keder groove is facing down.
PAGODA MANUAL (ALUMINIUM POLES)
6
Figure 1a
Figure 2a
Figure 3a
Figure 2b
Figure 1b
Figure 2c
Figure 3b
Publicité
Table des Matières
