Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
ASSEMBLY
TIP: Use a groundsheet to prevent the tent canvas f rom getting dirty during assembly
of the tent.
1.
Lay the corner pieces approximately the correct distance f rom each other.
2. Lay all the horizontal tubes between the corner pieces and connect them together using
the connector rods. See f igure 1b.
Pay attention - The horizontal tubes for the pagoda tent of 3 x 3 m are made in one piece.
3.
Fit the connected tubes into the corner pieces. Ensure that the keder groove is facing
down.
4. Connect the corners of the roof f rame diagonally with each other using the steel cables.
Tension the cables manually and evenly using the turnbuckles. Ensure that the f rame is
not skewed and ensure that the keder groove is facing down.
PAGODA MANUAL (WOODEN POLES)
14
Figure 1a
Figure 2a
Figure 3a
Figure 1b
Figure 2b
Figure 2c
Figure 3b
Publicité
Table des Matières
