Partyspace BONBO PAGODA Mode D'emploi page 7

5. Lay the roof canvas over the f rame. Pull the
nylon loops over the corners as indicated in
f igure 4. On one of the corners there is a
drawstring to make it easier to pull the last
loop over the corner.
6. Place the pole so that the roof canvas is
placed under tension. Slide the peak of the
roof over the top of the pole and slide the
pole base over the uppermost cross cable
into the centre. Aff ix the pole with the
attachment clamp at the bottom.
7. Attach the loops around the roof f rame to
the inside of the sloping sides of the roof
canvas. This gives the roof structure extra
support.
8. Place two poles on one side beneath the f rame so that the roof f rame lies at an angle (see
f igure 7a). Ensure that the widening of the keder groove is at the top of the vertical poles
and that the keder grooves are f itted at an angle of 45° in relation to the corners of the
tent (f igure 7b).
9. Place the two other poles in the same way and f it a base plate beneath each pole. Ensure
that the openings in the base plate correspond to the openings at the bottom of the pole,
so that you can aff ix the poles in the base plates.
PAGODA MANUAL (ALUMINIUM POLES)
7
Figure 7b
Figure 7a
EN
Figure 4
Figure 5
Figure 6