Heath Zenith SL-6050-WH Guide De Référence page 10

CAUTION: To avoid water damage and electrical shock,
keep lamp holders 30° below horizontal.
9. Adjust the lamp holders by loosening the lock nuts. Note: Do
not rotate the lamp holders more than 180° from the factory
setting.
10. Adjust lamp shades by loosening the screws several turns, turn
shades counterclockwise and remove. Reinstall the shades in
the desired position and tighten screws.
CAUTION: Do not exceed the maximum load limits
listed above.
11. Check operation. Activate transmitter being used with receiver
(see transmitter instructions). A signal will be sent to the receiver
to turn the receiver ON or OFF.
WARNING: Risk of fire. Do not aim the lamps at a
combustible surface within 3 ft. (1 m).
Bulb Replacement
CAUTION: When replacing the bulb, turn power off
and let the fixture cool.
IMPORTANT: Use a clean glove or cloth when handling the
new bulb. Use isopropyl (rubbing) alcohol to clean the bulb if
it is touched with your bare hands.
1. To remove lamp shade, loosen screw 2 full turns with a small
phillips-head screwdriver. Turn shade counterclockwise and
remove.
2. To remove bulb, pull straight out of fixture.
3. To replace bulb, push bulb pins into bulb socket. Check that
the bulb is seated properly.
4. To reinstall lamp shade, place shade on fixture and align notches
on shade with tabs on fixture. Turn clockwise. Tighten screw
firmly.
Screw
Removing Lamp Shade
10 200668-03