Connecting The Appliance To The Power Supply - AEG MCD2665E Notice D'utilisation

www.aeg.com
32
IMPORTANT! Ensure the bottom
of the oven is 85 cm or more
above the floor. It is important to
ensure that the installation of this
product conforms to the

9.2 Connecting the appliance to the power supply

(A)
instructions in this operation
manual and the conventional oven
manufacturer's installation
instructions.
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency.
Or it should be possible to isolate the
oven from the supply by
incorporating a switch in the fixed
wiring in accordance with the wiring
rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the
cupboard, see (A).
• Connect the appliance to a single
phase 220-240V/60 Hz alternating
current via a correctly installed earth
socket.
• The power supply cord may only be
replaced by an electrician.
• If the appliance is to be operated in a
non-European country, the supply
voltage, current type and frequency
of the appliance indicated on the
rating plate must correspond with
the specification of your power
supply. The rating plate can be found
on the inside face of the control
panel.
• Before installing, tie a piece of string
to the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into
the high-sided cupboard, DO NOT
crush the power supply cord.
• Do not immerse the power supply
cord or plug in water or any other
liquid.