Remington H5600 Instructions page 4

Masquer les pouces Voir aussi pour H5600:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
ENGLISH
Do not twist or kink the cable, or wrap it round the appliance.
Do not use the appliance if it is damaged or malfunctions.
Check the cord regularly for any sign damage.
Always keep the lid closed while the rollers are heating.
Ensure there is a roller on each slot while the unit is heating and that each roller is
properly inserted into the base unit.
DO NOT USE ON ARTIFICAL HAIRPIECES OR WIGS.
This appliance is not intended for commercial or salon use.
PARTS
1. Ionic flocked rollers
4 x 20mm (small)
10 x 23mm (medium)
6 x 27mm (large)
2. Colour coded clips
INSTRUCTIONS FOR USE
Before use, ensure the hair is clean, dry and tangle-free.
For extra protection use a heat protection spray.
Hairsprays contain flammable material – do not use while using this product.
Section the hair prior to styling. Style the lower layers first.
Plug the product into the mains power supply.
CAUTION : the appliance will begin to heat-up as soon as the power supply is switched
on.
The lid should be in the down position until the rollers are ready to use.
The rollers will start to heat up in 3 minutes. Allow 10 minutes for them to reach the
optimal curling temperature.
When the rollers are ready for use, the dot on top of the rollers will change colour.
Open the lid for 1 minute and begin to use.
TO CURL
Select the desired size of roller. Use the small rollers for tighter curls; the larger rollers
give looser curls and waves.
Take a section of hair, about the width of the roller.
Wrap the ends of the hair around the roller, keeping the hair at right angles to the
scalp.
Wind the roller right down to the roots.
Secure the roller firmly in place with the correct size pin or clip, as near to the scalp as
possible.
Repeat with the next section of hair.
Leave all the rollers in the hair until the rollers and hair have fully cooled down and set
the style.
4
3. Colour coded pins (not shown)
4. On indicator light
5. Ready indicator dot
6. Cool touch end
7. Base unit

Publicité

Table des Matières
loading

Table des Matières