Care And Maintenance - Hilti BX 3-ME Mode D'emploi Original

2. Slide the nail downwards out of the magazine.
3. Hold the nail pusher securely and press the nail pusher release button.
4. Guide the nail pusher back to its original position.
6.5.2 Removing a nail when in single-fastener mode
▶ To remove a nail that has been inserted into the fastener guide, proceed in the same way as for removing
a jammed nail (see → page 11).
6.6 Jammed nails
Individual nails may get stuck in the fastener guide. You can remove jammed nails from the fastener guide
with the aid of the X-NP drift punch set. Accessories are available from your Hilti Center or can be ordered
online at www.hilti.com.
WARNING
There is a risk of injury and damage to the fastening tool. Use of unsuitable items instead of the
recommended genuine Hilti accessories may result in injury or damage to the fastening tool.
▶ To release a jammed nail, use only the recommended drift punch set.
CAUTION
Risk of injury by flying parts! Triggering the tool (attempting to drive a fastener) when foreign objects
are present in the area around the fastener guide, or when a fastener is jammed in the fastener guide,
may lead to injury caused by flying objects or fragments.
▶ Never attempt to remedy tool malfunctions by continuing to trigger the tool.
6.6.1 Releasing jammed nails
1. Remove the fastener guide (see → page 8).
2. Fit the fastener guide into the supporting sleeve from the drift punch set.
3. Use the drift punch and a hammer to drive the jammed nail out of the fastener guide.
4. Fit the fastener guide (see → page 8).

7 Care and maintenance

7.1 Care of the fastening tool
▶ Remove plastic fragments from the fastener guide at regular intervals.
▶ Never operate the fastening tool when the air vents are blocked. Clean the air vents carefully using a dry
brush.
▶ Do not allow foreign objects to enter the interior of the fastening tool.
▶ Clean the exterior of the fastening tool with a slightly damp cloth at regular intervals.
▶ Do not use a spray, pressure jet washer or running water for cleaning.
▶ Keep the grips of the fastening tool dry, clean and free from oil and grease.
▶ Do not use cleaning agents containing silicone.
7.2 Maintenance
▶ To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. You can
find other spare parts, consumables and accessories approved for this product at your local Hilti Center
or online at: www.hilti.com.
7.3 Cleaning the inside of the nosepiece
1. Remove the fastener guide.
2. Clean the inside of the nosepiece.
3. Insert the fastener guide.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Printed: 24.08.2016 | Doc-Nr: PUB / 5269973 / 000 / 02
English 11