Table Des Matières - SERVODAN 44-063 Mode D'emploi

Installation
The PIR sensor 44-063 can operate on alkaline
batteries or with the adapter 23-513.
Batteries
Observe the following when putting in batteries:
1. Remove the battery cover with a fl at screwdriver.
Fig. 1
2. Put in 4 new AA 1.5 V alkaline batteries ensuring
correct polarity. Fig. 9
3. Replace the battery cover. The cover is the right
way round when the screwdriver symbol is
located opposite the screwdriver recess. Fig. 1
The working life of the batteries is determined by the
frequency of activation and the ambient temperature.
Under normal conditions the batteries can last for 6
months with 10 activations per day at 20°C. When
the batteries are empty, the LED will become dim and
the range of the transmitter will become shorter. New
batteries are put in as described above.
Fig. 9 Fig. 10
The sensor can be connected to the adapter instead
of using batteries. Use an adapter of type 23-513 in
which the adapter DC plug connects to the sensor's
socket.
1. Remove the battery cover with a fl at
screwdriver. Fig. 1
2. Insert the adapter DC plug into the sensor
socket. Fig. 10
3. Cut a hole in the cover of the adapter cable.
Fig. 11
4. Refi t the battery cover and ensure that the
cable fi ts through the opening. Fig. 12
Cable recess
Fig. 11 Fig. 12
The opening in the battery cover means that the
unit is no longer splash proof. It can be sealed with
silicone is required.
The batteries should be removed when an adapter is
used.
Wall and ceiling mounting of the sensor
1. Remove the screw that holds the bracket. Fig.13
2. Remove the bracket. Fig. 14
3. Fix the bracket on ceiling or wall with the
enclosed screws. Figs. 15 and 16
4. Position sensor in the bracket. Fig. 17
5. Clamp the sensor to the bracket with screw.
Fig. 18
Stainless steel
screw
Fig. 13 Fig. 14
Fig. 15 Fig. 16
Fig. 17 Fig. 18
Sensor positioned on table
Position sensor in the table bracket. Fig. 19
The sensor can be removed from the table bracket by
pressing the button. Fig. 20
If you want to change the detection area, the sensor
can be turned in relation to the bracket. Fig. 21
Fig. 19
Release
button
Degrees
Alignment point
0 ~ 90 o
0 ~ 90 o o
Fig. 21
Mounting
hole
Test and adjustment
METRE potentiometers
METRE
The metre potentiometer adjusts the distance from
1 to 8 metres.
Set METRE to the " - " position and the sensor's
range is approx. 1 metre.
P U S H
Set METRE to the " + " position and the sensor's
T O R E L E A S E
S E N S O R
>A B S < range is approx. 8 metre.
If the METRE potentiometer is set between the two outer
marks, the range can be set between 1 to 8 metres.
When fi tted on the ceiling above a door, it is
Fig. 20
recommended that you set METRE to the " + " position.
LED
LED Fig. 23 lights when the sensor is activated for
approx. 5 seconds.
Fig. 22
LED
Fig. 23
5(18)