Chapter 13 | Final Notes - DRAMINSKI Twist Grain pro Mode D'emploi

– The grain moisture meter should be protected against di-
rect impact of water Avoid using it in alternately extreme
temperatures You cannot allow water vapour condense
on the metal parts of the device because it might have an
influence on the measurement results
– At the end of a season when you finish working with the
device, you need to clean and dry the measuring cham-
ber and the tightening cap properly The device must be
kept in a dry and warm room Proper maintenance and
storage conditions guarantee long life and reliability of
the device
– If you are not going to use the device for a longer time,
it is recommended to take out the batteries from the
battery compartment in order to limit the risk of dam-
age of the device due to leakage of the electrolyte
It is recommended to use batteries of recognised
manufacturers
54

CHAPTER 13 | FINAL NOTES

– If any problems appear with the device or when inter-
preting the results, it is recommended (before sending
the device to the service) to contact the manufacturer,
that is DRAMINSKI S A or the nearest authorized distrib-
utor This contact is important especially before sending
the device to the warranty servicing because most of the
problems can be solved remotely However, when you
send properly operating device groundlessly, you will be
charged with costs of maintenance and shipment
– It is forbidden to dismantle the device, to interfere or
maintain it by unauthorized people, because it might
cause permanent damage and it will invalidate the war-
ranty
– Pay attention to the rubber shield of the mini-USB slot,
because when it is missing, the slot is exposed to dirt