DRAMINSKI Twist Grain pro Mode D'emploi page 20

urements from which the average is calculated can be
changes in the main menu
– To enable saving the measurement results to the mem-
ory of the device, it is necessary to run the advanced
mode (additionally in the main menu of the device you
can choose if the saved result must be the average of
the measurements)
– In order to save the measurements from an external
probe to the memory of the device, it is necessary to
turn to the advanced mode and in the settings you
should give this probe a name (it is important because it
helps the results to be properly catalogued)
– If you notice some important deviations in the results
for a certain species which increase or decrease the
value in the whole measurement range in comparison to
the laboratory method (drying and weighing method),
it is recommended to modify the measurements (see
CHAPTER: MODIFICATION OF HUMIDITY RESULTS)
– Every species has a different range of the measured
humidity However, its exceed is signaled by a proper
sign, for example:
"<8.5%" (below the range), when the humidity of the
tested sample is less than 8 5%,
">35.0%"(above the range), when the humidity of the
tested sample is more than 35%
CHAPTER 5 | NOTES FOR MEASUREMENTS
EN
19