Human Touch HT-Navitas Ascent Serie Mode D'emploi Et D'entretien page 5

get ready
ASSEMBLE THE CHAIR
1. Install the armrests.
a. Align the four holes on the armrest mounting bracket with the corresponding holes on the chair frame.
b. Using a 5mm Allen wrench (provided), install one Allen screw with flat-washer into each of the four mounting
holes to secure the armrest to the chair.
Armrest
c. Connect the air two air tubes on the armrest to the corresponding air tubes on the chair (yellow/yellow, black/black),
then secure each connection tightly using a provided zip-tie.
d. Repeat steps 1 – 3 to install the other armrest.
humantouch.com
4 mounting holes
Flat washer
Allen screw
Zip ties
Yellow air tubes
Black air tubes
6
Next install the armrests, side panels, and power cord.
Don't worry—it's easier than it sounds!
2. Install the side panels.
a. Align the four side panel holes with the corresponding mounting holes on the armrest, then push the side panel firmly
into place (Fig.A).
b. Using a flat-head screwdriver, pry the top of one of the fasteners up off of the fastener base and hold it in that position (Fig.B).
c. Using your other hand, locate one of the four side panel mounting holes on the inside of the armrest (Fig.C).
d. Push the base of the fastener firmly and completely into the hole, then push the top of the fastener firmly inward to lock it.
e. Repeat steps (b) and (c) to install the other three fasteners. NOTE: Access the upper right mounting hole from the inside of
the arm, near the seat cushion.
f. Repeat steps (a) to (e) to install the other side panel.
Side panel
Fig. B
Fig. A
3. Install the power cord and power on the chair.
a. Plug the power cord into the power jack on the back of the chair.
b. Plug the other end of the power cord into a grounded 120V outlet.
c. Turn the power switch on the back of the unit to On (I).
4. Press the Power button on the remote control to power it on.
When you have ensured that the area around the chair is free from children and pets
(and will remain that way for the duration of the chair's use), select CONTINUE.
Fasterner
Mounting holes
Fig. C
Power cord
Power switch
7