Choose A Location - Human Touch HT-Navitas Ascent Serie Mode D'emploi Et D'entretien

get ready
Unpack the box
Chair base
Power cord Zip ties (6)
Fasteners (8)

CHOOSE A LOCATION

When deciding where to place your HT-Navitas, consider the following:
• Place the unit on a flat surface, away from direct sunlight or any other direct heat source (to avoid fading).
• If you wish to place the unit on a hard surface, it is recommended that you place a piece of carpet or a soft mat
underneath it to avoid damaging the floor (minimum 48" x 28").
• To accommodate the footrest when deployed, make sure the area in front of the chair is clear for at least 32".
32"
Clearance
humantouch.com
Armrests
Side panels
5mm Allen screws (10) Flat washers (10)
5mm Allen wrench (1)
4
In just a few minutes you'll be enjoying your new Human Touch
massage chair! But first unpack the box, make sure you have
all of the parts, choose a location carefully, and then use two
people to move your chair to the desired location.
MOVE THE CHAIR TO THE DESIRED LOCATION
CAUTION: Use two or more people to lift the chair out of the box or move it, to avoid injury or damage to the chair.
Do not move the chair with anyone seated in it. Do not hold the seat, front of the footrest, or shoulder unit when
moving the chair. Make sure the power cord is secured out of the way before moving the chair.
To move the chair:
1. Carefully push down on the upper part of the backrest to tilt the chair backward, balancing the chair weight
carefully to avoid dropping it.
2. Roll the chair on its casters to the desired location.
3. Gently lower the chair all the way to the floor. WARNING: Dropping the front of the chair to the floor may damage
the chair and/or floor.
Caster
5