Cleaning
Routine cleaning of your treadmill will extend the product's life.
Important : Nover use abrasives or solvents to clean the treadmill. To prevent damage to the computer,
•
keep liquids away and keep it out of direct sunlight.
After each workout : Wipe off the console and other treadmill surfaces with clean, water dampened
•
soft cloth to remove excess perspiration.
Weekly : Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the
•
belt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.
Deck Lubrication
The walking belt has been pre-lubricated at the factory. However , it is recommended that the working board
be checked periodically for lubrication to ensure optimal treadmill performance. Usually your treadmill should
not have to be lubricated usually within the first year or 500 hours of use.
Every 4 weeks or 20 hours of operation lift the sides of the walking belt and feel the top surface of the
walking board as far as you can reach. If there are signs of silicone, no further lunrication is required. If it
feels dry to the touch, follow the instructions below. Please use a non-pertroleum based silicone.
To apply luburicant to the walking belt:
1.
Position the walking belt so that the seam is located on top and in center of the walking board.
2.
Insert the spray nozzle into the spray head of the luburicant can.
3.
While lifting the side of the walking belt, position the spary nozzle between the walking belt and the
board approximately 6 cm from the front of the treadmill. Apply the silicone spary to the walking
board, moving from the front of treadmill to the rear. Repeat this on the other side of the belt. Spary
approximately 4 seconds on each side.
4.
Allow the silicone to "set" for 1 minute before using the treadmill.
Spray lubricant from front to back.
5