Chauvet Professional EPIX DRIVE 642 Guide De Référence Rapide page 5

ÉPIX™ Drive 642 QRG
Mounting
Mounting
Guidelines
The ÉPIX™ Drive 642 has four (4) mounting points (one on each corner)
with 13 mm holes to which you can install screws and mount this product
directly to almost any flat surface, truss, or other load bearing structure in
any orientation. The product may also be installed with clamps for
hanging on truss. You must supply your own clamps and make sure the
clamps are capable of supporting the weight of this product.
Chauvet recommends using the following guidelines when mounting this
product:
·
Make sure to mount this product away from any flammable material
as indicated in the
·
Never mount in places where rain, high humidity, extreme
temperature changes, or restricted ventilation may affect the product.
·
Before deciding on a location, always make sure there is easy access
to the product for maintenance and programming.
·
Make sure that the structure or surface onto which you are mounting
the product can support the product's weight (see the
Specifications).
·
When mounting the product overhead, always use a safety cable.
Mount the product securely to a rigging point, such as an elevated
platform or a truss.
·
When rigging the product onto a truss, you should use a mounting
clamp of appropriate weight capacity.
·
When mounting the product on the floor, make sure that the product
and cables are away from people and vehicles.
Safety Notes section.
5
EN
Technical