Selection Of A Sound Effect; Bluetooth ® -Operation - Renkforce TB378 2.0 Mode D'emploi

While setting the volume or with muting activated, the corresponding operating display (7) will flash.
When you have reached the maximum volume and push the button VOL+, the operating display (7) will
flash once. When you have reached the lowest volume and push the button VOL-, the operating display (7)
will flash once.
d) Selection of a sound effect
• Push the NEWS/MOVIE/MUSIC (23) buttons at the remote control to set the desired sound effect:
NEWS > Setting for news
MOVIE > Setting for movies
MUSIC > Setting for music playback
e) Bluetooth -operation
®
When you use your Bluetooth
process is called "pairing". After connection, the soundbar will recognise your Bluetooth
Bluetooth mode is on. However, observe that establishing the connection may take several seconds. If no connection
®
is established within two minutes, the soundbar will switch to the last connected audio source.
The transmission range is approx. 8 m at direct sight. Objects that are located between the Bluetooth
devices may reduce the transmission range.
Before coupling, check the technical data of your Bluetooth
devices. A password for coupling must be entered in some mobile devices. Enter "0000" in this case.
If the Bluetooth
is stronger again, the connection is re-established automatically.
Manual pairing
• Switch on the soundbar with the
• Push the SOURCE (5) button at the soundbar repeatedly or the BT (19) button at the remote control to switch on
Bluetooth mode. The operating display (7) flashes blue slowly.
®
• Keep the /PAIR (22) button pushed for approx. three seconds. The TV soundbar switches to pairing mode and
emits the acoustic message "Pairing" as confirmation. The operating display (7) flashes blue quickly.
• Activate Bluetooth on your mobile unit (e.g. Smartphone) and start search for Bluetooth
®
40
device with the soundbar for the first time, both devices need to be connected. This
®
signal grows weak, the connection to the soundbar may be disconnected. Once the signal
®
(6) button at the speakers or the
device automatically when
®
device. Compatibility is not ensured with all
®
(17) button on the remote control.
devices.
®
®