Call Up Pre-Programmed Scanner Programs; Programming - Futurelight CP-16 SC3 Mode D'emploi

Select LED on (selection of gobos)
- Program-run
0 Blackout
1 White
2 Glass gobo
3 Gobo 1
4 Gobo 2
5 Gobo 3
6 Gobo 4
7 Gobo 5
8 Gobo 6
9 Gobo 7
A Gobo 8
B Static gobo - mix 1
C Static gobo - mix 2
D Synchronized change gobos
E Synchronized change gobos
F Static gobo - mix 3

Call up pre-programmed scanner programs

- Choose the desired projectors with the projector select switches 1-4 (LED is permanently on)
- Choose program 11-20
- Switch off the blackout-function (LED off)
Speed selection
If the Audio/Pulse button is in the "PULSE" -position (LED is off), the FUTURELIGHT EFFECTS move at the
speed adjusted with the speed button. If the Audio/Pulse button is pressed (LED is off), the FUTURELIGHT
EFFECTS move at every beat of the music.
Caution: In order to activate the sound control, you have to connect the controller to the mixer first. If the
controller does not receive a sound signal, the mirror does not move.
Speed adjustment in the pulse-mode
The speed-button only works in the program run and in the program mode. If you press the speed button, the
display shows the current value. You can adjust the speed with the UP/DOWN buttons.
Connecting one program with another
Choose the desired program and press the program button. The display shows a dot next to the program
number. With the UP/DOWN buttons you can choose the programs to be connected and confirm by pressing
the program button. The programs you have chosen are once run through from the lowest to the highest number.
The controller runs through the program run until you stop it by erasing the dot. You can erase the dot by
pressing the program button once more.
Caution: The program run is not memorized. As soon as you turn the device off, the program run is lost.

Programming

Choose one of the freely programmable chasers between 1 and 10 with the program button (e.g. program
1).Press the speed button in order to adjust the speed. The display shows the current speed. Choose e.g. the
standard speed 5, which provides a high memory frequency (10x/sec.) and a short program duration. This
speed is particularly suitable for slow movements as the high frequency provides soft beam movements. You
can choose the speed between 1 (50x/Sec.) and 99 (1x/2Sec.).
Press the write button and the display shows "00" (flashing). Choose the desired projectors with the projector
select buttons. The respective LED has to flash.
Adjust the settings with the Gobo/Strobo Up/Down buttons and the Colour Up/Down buttons.
Move the mirror with the joystick to the starting position.
The different values of the Gobo/Strobo display are:
Select LED off (strobe selection)
Program-run
Blackout
Strobe program synchro - speed 1
Strobe program synchro - speed 2
Strobe program synchro - speed 3
Strobe program synchro - speed 4
Strobe program synchro - speed 5
Strobe program running "point" - speed 1
Strobe program running "point" - speed 2
Strobe program running "point" - speed 3
Strobe program running "blackout" - speed 1
Strobe program running "blackout" - speed 2
Strobe program projector 1-4, 2-3 - speed 1
Strobe program projector 1-4, 2-3 - speed 2
Strobe program projector 1-3, 2-4 - speed 1
Strobe program projector 1-3, 2-4 - speed 2
RESET
1 3