Features; Start - Up; Overview Over The Function Buttons - Futurelight CP-16 SC3 Mode D'emploi

Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
If you want to move the device please use the original packaging in order to avoid transport damages.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!

Features

- Programmable DMX-controller for the Futurelight effects Scan SC-330, SC370
- 4 scanner addresses can individually be controlled and memorized
- The joystick channels can be selected individually via a setup. In this way, all DMX-effects with up to 4 channels
can be controlled
- 10 pre-programmed programs
- 10 freely programmable chasers in real-time
- Storage capacity 60 seconds per program
- Combination of different programs possible (e.g. 1-4-8)
- Joystick for manual mirror-control
- Effect selection via push-buttons

Start - up

Connect the CP16 SC3 to the mains (230V/50Hz).
Is the CP16 SC3 supposed to work via a soundsignal, connect the ¼ „ jack plug mono with the soundsignal of
your headphones output or a second adjustable output (if existing) of your mixer, or with the loud-speaker output
of your amplifier.
Never connect the sound input with the DMX output,
Connect the DMX output of the CP16 SC3 with the DMX input of the nearest Futurelight Scan SC-330, SC370.
A splitting of the data line is not possible.
Use a data line appropriate for RS-485, 250Kbaud data use or a shielded quality double-wire cable. As plug
contact use ¼ „ jack plugs stereo or 3 pin XLR connector, the terminals of which are as follows:
Tip:
Ring:
Sleeve:
Termination is not necessary.
Caution: At the last scanner, the DMX-cable has to be terminated with a 120
into a 3 pin XLR connector and plug it in the DMX output of the last scanner.
Caution: When you turn the device on, the controller is in blackout-mode (Blackout-LED on).

Overview over the Function Buttons

1) POWER SWITCH
2) DISPLAY COLOUR SETTINGS
3) COLOUR UP/DOWN BUTTONS
4) GOBO/STROBO DISPLAY
5) GOBO/STROBO UP/DOWN BUTTONS
6) GOBO/STROBO SELECTOR BUTTON
If the LED is on, you can choose the desired gobo. If the LED is off, you can choose the strobe effect.
7) OPERATING DISPLAY
8) OPERATING UP/DOWN BUTTONS
9) PROGRAM BUTTON
With the program button you can choose the different programs
1-10 Freely programmable chasers
11-20 Pre-programmed programs
10) SPEED BUTTON
11) WRITE BUTTON
Tip:
Sleeve:
Caution:
as this will destroy the electric (DMX driver).
Data +
Data -
Mass
Data +
Mass
PIN 1: Mass
PIN 2: Data -
PIN 3: Data +
1 1
resistor. Solder the resistance
W