Introduction; Safety Instructions; Operating Determinations - Futurelight CP-16 SC3 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY
Every person involved with the installation, operation and maintenance of this device have to:
- be qualilfied
- follow the instructions of this manual
a dangerous electric shock when touching the wires !
Thank you for having chosen a CP16 SC3.
The CP16 SC3 is a DMX controller especially designed for the Futurelight effects Scan SC-330, SC-370.
The CP16 SC3 features four addresses. The number of effects per address is unlimited.
Unpack your CP16 SC3.
Before your first start-up please make sure that there are no damages caused by transportation. Should
there be any, do not take the device into operation and consult your dealer.
This device has left our premises in absolutely perfect condition. In order to maintain this condition and to ensure
a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written
in this user manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or problems.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation water might damage your device. Leave the device switched off until it
has reached room temperature.
Never let the AC-cord come into contact with other cables! Handle the AC-cord and all AC-connections
with particular caution! Never touch these parts with wet hands!
Make sure that the available voltage is not higher than stated on the device.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs !
There are no servicable parts inside the device. Maintenance and service operations are only to be carried out
by authorized dealers.
Use in closed rooms only.
Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless, disconnect
from mains immediately. Please let the device be checked by a qualified service technician before you operate
it again. Any damages caused by liquids having entered the device are not subject to warranty!
You can install the device at any desired place. Please make sure that the device is not exposed to extreme
heat, moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Keep this device away from rain and moisture !
Unplug mains lead before opening the housing !
BEFORE YOU INITIAL START - UP!
Caution ! Be careful with your operations.
With a voltage of 230 V you can suffer

Introduction

Safety Instructions

Operating Determinations

CAUTION !
1 0

Publicité

Table des Matières
loading

Table des Matières