Utility - Beta 1760DGT/2 Manuel De L'utilisateur

2. Press F2 to select a type of cursor measurement.
3. Press F3 to select the channel that needs to be measured.
4. Press F4 to enter the second page, press F1 or F2 to select Cursor1 or Cursor2,
press up, down, left and right to move Cursor1 or Cursor1;
5. The result of cursor measurement will be displayed on the cursor menu.
Automatic Measurement
The oscilloscope provides 2 kinds of automatic measurements, including frequency and
amplitude.
Press Menu button to enter, select Measure to enter automatic measurement. Press F1
to open, the measurement results will be displayed on the top left corner of the screen.
Measurement Menu Table
Menu Description
Frequency Measure the frequency of the signal.
Maximum
Measure the maximum voltage of the signal.
Voltage
Minimum
Measure the minimum voltage of the signal.
Voltage
Attention:
In the measurement result, the yellow font is the result of CH1, and the green font is the
result of CH2.

Utility

Press Menu button to enter.
Utility Menu Table
Menu Setting
中文
Language English
Italian
On
Sound
Off
Backlight
1~10
luminance
30s
60s
Backlight
90s
time
120s
Unlimited
Description
Set the menu language.
Open the key sound.
Close the key sound.
Set backlight brightness of the screen.
Set the screen backlight time.
66