Save Waveform; Reference Waveform - Beta 1760DGT/2 Manuel De L'utilisateur

Save Waveform

Press Menu button to enter, and select Save to enter store waveform menu. The waveform
can be saved to the oscilloscope inside, also can be recalled to view.
The Save Menu Table
Menu Setting
Position 1,2,3,4,5,6
Save
Recall
To save the waveform, follow these steps:
1. Press F1 to select the storage position of the waveform.
2. Press F2 to save the waveform data to the specified position. Also users can long press
button to enter, and select F4->F2 (Data Save) as shortcut keys. Press
button one time to save the current waveform data.
3. Press F3, recall the saved waveform. The waveform can be enlarged or reduced in the
Channel or Time menu by using the direction keys.
Attention:
1. Waveform storage can not only save the waveform of the current channel, but also
save the current state settings at the same time.
2. Users can permanently store 6 waveforms in the oscilloscope memory and rewrite
them at any time.

Reference Waveform

The REF channel is used to display the reference waveform, which can compare the actual
waveforms with the reference waveforms so as to find out the differences.
Press Menu button to enter, and select Ref to enter reference Waveform menu.
REF Menu Table
Menu Setting
Ref-A
Position
Ref-B
On
Enable
Off
CH1
Source
CH2
Save
To save the reference waveform, follow these steps:
1. Press F1 to select the position of the reference waveform.
2. Press F2 to open the REF channel.
Description
Select the internal storage position.
Save waveform data.
Recall the waveform.
Description
The REF waveform is saved to the oscilloscope
Ref-A or Ref-B.
Open the REF waveform.
Close the REF waveform.
Select CH1 to save as a REF waveform.
Select CH2 to save as a REF waveform
Save the REF waveform.
64