Marmitek M229 Notice D'utilisation page 16

ENGLISH
EX-229D EXTRA DOOR UNIT INSTALLATION
You can connect up to 4 door camera's to the M229 system. The button for the electrical door lock
works for the camera activated.
2 Wires to connectors
of the Main Unit
EX-229D SYSTEM SETUP FOR ADDITIONAL DOOR UNITS
• Press and hold the left button of the Main Unit (7) for at
least 2 seconds to enter in the Setup mode. The Menu
appears on the screen.
• Step through the menu by pressing the left (7) and right (9)
button of the Base Unit. Select the camera corresponding
with the Terminal number the camera is connected to.
Activate the camera by pressing the middle button (8). Pick
up the handset and replace it to exit the setup mode.
Handset and replace it to end the Setup mode.
EX-229D USING THE 2nd, 3rd AND 4th DOOR UNIT
The EX-229D functions in exactly the same way as the first camera connected to the Base Unit.
AUDIO / VIDEO OUT
The main monitor of the M229 system has an audio/video out. This connection makes it possible to
view camera images on a TV or video monitor. The M229 can also be connected to a recorder or
PC with video in. This function does not work with the built-in memory.
A connecting wire is included. The colour codes are:
White: Audio out
Yellow: Video out
The AV OUT trigger contact is a NO (normally open) contact. When the monitor is activated, the
contact is closed. You can use this contact to e.g. start a VCR.
When you want to extend the cable, you need to use a shielded or coax cable.
16
2 Wires to connect the Lock Release Control (if available).
Black: GND (mass for audio and video)
Brown: AV OUT trigger
© MARMITEK