Connectors; Installation - Fbt StageMaxX 12Ma Mode D'emploi

The 3-pole XLR connectors are almost always used for conducting mono balanced signals; the three poles
correspond respectively to ground (1), the positive signal (2) and the negative signal (3).
The STAGEMAXX speaker is suitable for floor or wall installation by special wall bracket.
STAGEMAXX sound speaker must be installed using the flying accessories described in this manual and following
the special assembly instructions by qualified staff only, strictly complying with the current regulations and safety
standards in force in the country of installation.
FBT flying accessories are manufactured for their exclusive use with STAGEMAXX systems and have not been
designed for being used with any other speaker or device.
Any possible elements of the ceiling, floor or further supports where STAGEMAXX systems are to be installed shall
be able to safety bear the load. The flying accessories in use are to be coupled and secured safety to both the sound
speaker and the ceiling (or the other support).
When components are fitted to ceilings, floors or beams, always make sure that all couplers and fixing elements
are properly sized and have an adequate load capacity.
Besides the main suspension system, all flying speakers in theatres, indoor stadiums or in several other work
and/or leisure facilities shall be provided with an additional independent safety system with the adequate load
capacity. Only steel cables and chains with certified load capacity can be used as an additional safety device.
- Hang STAGEMAXX speakers using only original accessories.
- When choosing the place of installation, the suspension cable and the mounting supports make sure they are able
to bear speaker and flying accessories weight with the proper safety factor.
- As for fixed installations, always schedule and carry out special inspections on a regular basis in order to check all
the parts that have to guarantee system safety over time.
- Do not hang the system by the handles: handles have been designed for speaker transport and are not suitable for
its suspension.
- Never lean on/hang from the flying speaker.
FBT elettronica SpA accepts no responsibilities for any possible damages or injuries due to the use of
supports or structures not strong enough or due to wrong installation.
maschio
male
femmina
female
schema
diagram

CONNECTORS

! !

INSTALLATION

UK
ATTENTION
15