Working Advice; Maintenance And Service; Français; Consignes De Sécurité - Bosch GTA 60 W Professional Notice Originale

10 | Français
J
I
J
Manufac- Model
turer
Bosch GTS 10
GTS 10 XC
GTS 10 J
GTS 635-216
GTS 18V-216
DeWalt DW744XP
Metabo TS 250
Makita 2703
Hitachi C 10 R A 2
– Position the power tool over the corresponding mounting
holes.
– Screw together the mounting plate and power tool using
the compatible screws, washers and nuts.
Operation

Working Advice

Before commencing work, ensure that the locking
mechanism (2) is always closed.
Always hold the workpiece firmly in place, especially long,
heavy pieces. Once the workpiece has been cut, the centre
of gravity may be displaced, causing the saw stand to tip
over.
Do not overload the saw stand. Always observe the max-
imum load bearing capacity of the saw stand.
Transport (see figure H)
You must fold the base unit together for transport.
– To release the lock bolts (4), gently push the saw stand
downwards by the handle (3).
– Open the locking mechanism (2).
This retracts the lock bolts which lock the wheels.
– Place one foot on the foot support (10) and pull the
handle (3) upwards with both hands until the lock bolts
engage again.
1 609 92A 5YE | (23.10.2020)
– Close the locking mechanism (2).

Maintenance and Service

After-Sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you
with any questions about our products and their accessor-
ies.
J
In all correspondence and spare parts orders, please always
include the 10‑digit article number given on the nameplate
of the product.
Mounting hole
Malaysia
Robert Bosch Sdn. Bhd.(220975-V) PT/SMY
B
No. 8A, Jalan 13/6
46200 Petaling Jaya
B
Selangor
J
Tel.: (03) 79663194
Toll-Free: 1800 880188
T
Fax: (03) 79583838
T
E-Mail: kiathoe.chong@my.bosch.com
www.bosch-pt.com.my
D
Me
You can find further service addresses at:
www.bosch-pt.com/serviceaddresses
M
H
Disposal
Saw stands, accessories and packaging should be recycled
in an environmentally responsible manner.
Français
Consignes de sécurité
Consignes de sécurité générales
Consignes de sécurité pour supports de travail
Débranchez l'outil électroportatif de la prise secteur
u
et/ou retirez l'accu avant de procéder à des réglages
et à des changements d'accessoires. La mise en route
intempestive des outils électroportatifs est une cause fré-
quente d'accident.
Installez correctement le support de travail avant de
u
fixer l'outil électroportatif. Un montage correct est pri-
Lisez tous les avertissements et instructions
joints au support de travail ou à l'outil élec-
troportatif à monter. Le non-respect des ins-
tructions et consignes de sécurité peut provo-
quer un choc électrique, un incendie et/ou en-
traîner de graves blessures.
Bosch Power Tools