Storage And Transportation - FUXTEC FX-BV140 Mode D'emploi

Clean the engine regularly with a cloth or brush. Keep the cooling system (area of the housing fan) clean to
allow proper air circulation, which is essential for engine performance and life. Be sure to remove all grass, dirt,
and combustible deposits from the muffler area.

STORAGE AND TRANSPORTATION

11.
Storage
The following steps should be taken to prepare the mower for storage.
1. Empty the tank.
a) Empty the fuel tank with a suction pump.
CAUTION! Do not drain the gasoline in closed rooms and the immediate vicinity of open fire etc. Do not
smoke under any circumstances! Gasoline vapors can cause explosions or fires.
b) Start the engine and let it run until it has used up all remaining fuel reserves and deposits.
c) Remove the spark plug. Use an oil can to fill approx. 20 ml of oil into the combustion chamber. Operate the
starter to distribute the oil evenly over the combustion chamber. Reinsert the spark plug.
2. Clean and grease the scarifier carefully, as described in the upper chapter "Use of Grease."
3. Lightly grease the blades to prevent corrosion.
4. Store the scarifier out of reach of unauthorized persons and in a dry, clean, and frost-free place.
CAUTION! The engine must be completely cooled down before storing the lawnmower.
NOTE: When storing any type of power equipment in an unventilated or material storage facility,
- it must be ensured that the device is stainless. Coat the device, especially cables and all moving parts, with
light oil or silicone.
- Make sure that you do not bend or kink any cables.
- if the starter cable comes loose from the cable guide on the handle, disconnect and ground the spark plug
wire, press the blade control lever, and then slowly pull the starter cable out of the engine. Slide the starter
cable into the cable guide pins on the handle.
Transportation
1. Move the transport lever into the transport position.
2. Switching off the engine
Danger!
Before transport, always switch off the engine and let it cool down and remove the spark plug connector. The
device must not be tilted during transport. When transporting the scarifier in or on a vehicle, make sure that it
does not move unintentionally.
Empty the fuel tank before transporting the device. The fuel tank cap must be firmly closed.
Original User Manual FUXTEC FX-BV140_de_en_fr_ita_rev04
19