Replacing The Roller - FUXTEC FX-BV140 Mode D'emploi

1. Stop the scarifier and disconnect the spark plug cable before changing the cutting height of the device.
2. To change the cutting height, turn the front knob clockwise or vice versa to the desired height.
3. Move the transport lever to transport position to prevent the mowing deck from touching the ground when
the work is finished.
Blade up
Fig.10A Fig.10B

6. REPLACING THE ROLLER

CAUTION: Make sure to wear work gloves.
Caution: Only use original scarifier/aerator shafts approved by the manufacturer.
The device can be mounted with the scarifier roller or the aerator roller.
Only replace the roller with an original roller as this ensures optimum performance and safety under all
conditions.
To change the scarifier roller or the optionally available aerator roller, proceed as follows
1. Switch off the engine and let it cool down.
2. Remove the spark plug connector.
3. Remove the grass catcher box.
Lift the device slightly at the front.
Note: Do not lift the machine too high. Otherwise, fuel may leak from the tank. Drain fuel if necessary
before changing the roller.
Original User Manual FUXTEC FX-BV140_de_en_fr_ita_rev04
Blade down
15