Thermador Masterpiece Serie Notice D'installation page 2

Align the outer flanges
with the outside of the
universal brackets. Fasten
with one ( 1 ) screw each
into the end hole of each
universal bracket.
Tighten screws securely,
but do not overtighten.
3. Place the speed oven or microwave unit on top of the
universal connector brackets and fasten in place using
three (3) screws per side. Tighten the screw securely,
but do not overtighten.
Note: The existing screws in the speed oven base
help with alignment. When lowering the speed
oven or microwave
universal connector brackets, allow these screw
heads to slide into the slots as shown in the
illustration below. The screw nearest the front of
the speed oven or microwave should slide into the
base of the slope at the front of the bracket.
4. Continue to the corresponding section depending on your
oven type.
Connecting the Speed Oven to the
Lower Oven
Note: When installing the combination unit, the speed
oven power cable must be properly attached to the
oven-mounted junction box. This must be done prior to
supplying electrical power to the oven unit.
A WARNING
Check to be sure that no electrical power has
yet been supplied to the oven.
2
into place on the
Speed Oven Models
MEDMC301WS
PODMC301W
MEDMCW31WS
PODMCW31W
1. Remove the oven-mounted junction box cover located
on the top rear of the oven. (See image below).
2. Remove the cap from the conduit access hole in the
side of the oven-mounted junction box.
3. Guide the wires from the conduit cable (coming from
the speed oven through the hole in the oven-mounted
junction box. (See image below)). There are four wires
from a speed oven.