Setting The Shielding Gas Volume; Feeding In The Wire; Torch Handle Control Elements - Binzel Abicor ABIMIG A LW Mode D'emploi

5 Putting into operation

5.7 Setting the shielding gas volume

5.8 Feeding in the wire

5.9 Torch handle control elements

EN - 18
NOTICE
• The type and amount of shielding gas used depend on the welding task
and the gas nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly before connecting
the cylinder. This will expel any impurities that may be present.
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
NOTICE
• Each time the wire is replaced, make sure that the start of the wire is free
of burrs and not bent.
1 Lay the cable assembly connected to the machine side out straight.
2 Insert the wire into the wire feeder as specified by the manufacturer.
3 Press the 'zero-current wire feed' trigger on the wire feeder until the wire
comes out of the contact tip.
NOTICE
®
• The ABIMIG welding torch must only be operated by qualified
personnel (in Germany, see TRBS 1203).
• Please also consult the operating instructions for the welding
components, welding power source and welding torch.
The trigger's two-cycle mode can be activated when using a standard welding
torch. Further operating modes (e.g. 4-cycle) and torch handle modules
depend on the welding power source and must be ordered separately.
®
ABIMIG