Binzel Abicor ABIMIG A LW Mode D'emploi page 31

®
ABIMIG
®
ABIMIG A T LW
®
ABIMIG W T
1
10
1 Torch neck
2 Insulating piece
3 Torch handle
4 Cable assembly
Fig. 3 Mounting the liner for ABIMIG
For use of steel wires with divided wire guide.
1 Stretch out the BIKOX
contact tip from the torch neck.
2 Unscrew the nut from the central connector and slide the liner through the
®
BIKOX
/cable assembly up to the retaining nipple.
3 Screw down the nut again, tighten using an ABIMIG
excess length at the handle threaded part so that it protrudes 2 mm.
4 Screw down rotating or repluggable torch neck again at the handle.
For use of steel wires with divided wire guide.
2
40
53
5 Connection nut
6 Nut
7 Central connector
®
W T torches
1 Disconnect the cable assembly (4) on the machine side and lay it out
straight.
2 Unscrew and remove the torch neck (1).
®
/cable assembly and unscrew the gas nozzle and
3 4
9
5 Putting into operation
®
wrench and cut off
5
14
8 Switch key wrench
9 Liner
10 Sealing plug
EN - 11
6
7
8