Battery Replacement - GUZZINI SOIREE Mode D'emploi

EN
• The lamp turns on and off with a simple touch (figure E).
• By holding down you get the dimming effect, which increases or decreases the light intensity
(figure F)
VERSION B – CODE 0458.01
ASSEMBLY INSTRUCTIONS
1) External dome, 2) lighting fixture with removable USB lid, (figure B)
• Place the lamp on the bench-top.
• Unhook the external dome(1) from the lighting fixture(2) by pressing the sides of the lighting fixture(2)
hook (figure A1). Let the lighting fixture (2) slide gently.
• Take the external dome (1) and place it over the lighting fixture (2) making the hook come out from the
slot.
• Only the lighting unit (5) equipped with USB cap, is considered for outdoor use, ensuring an IP54
protection rating.
INSTRUCTIONS FOR CHARGING THE BATTERY
CAUTION:
The battery must be charged in dry environments.
It is recommended to fully charge the battery on first use.
• Remove the USB lid from the lighting fixture (figure C)
• Insert the power supply (5V-2A USB characteristics - not supplied) into the power socket. "The Class
III appliance must be powered by a SELV source or equivalent" (e.g. complaint with 62368-1 – type ES1)"
• Connect the terminal with the USB-micro plug in the appropriate socket (pay attention to direction)
placed in the base of the lighting fixture (2) (figure G) and make sure that during charging the product is
firmly resting on a plane to avoid it falling.
• A blue LED, positioned near the USB socket, lights up during charging and turns off when charging is
completed. The battery recharges in about 8 hours, obtaining an optimal charge level. If during charging
the blue LED flashes, it means there are problems:
- The internal and/or external temperature drops below 0°C or rises above 45°C, charging automatically
stops and this is highlighted by the flashing of the blue LED. Once the atmospheric conditions have been
restored, the blue LED lights up steadily again;
- The battery is damaged (see paragraph "How to proceed in case of request for assistance").
• Autonomy when fully charged is about 9 hours. If the lamp is on and connected to the battery charger,
the indicated charging times are not guaranteed;
• When the red LED, positioned near the USB socket, lights up, it means that the battery has dropped to
10%. Moreover, to save battery life, do not leave it connected to the feeder when the blue LED is off.
• The lamp turns on and off with a simple touch (figure E).
• By holding down you get the dimming effect, which increases or decreases the light intensity (figure F)
MODEL PROTECTED BY COMMUNITY DESIGN REGISTRATION

BATTERY REPLACEMENT

The battery is inserted directly inside the lighting fixture (2). IT IS STRICTLY FORBIDDEN to open and
12
replace the battery with another non-original one in order to avoid malfunction of the electronic circuit and
failure of the same. Contact a dealer to replace the battery (see paragraph "How to proceed in case of
request for assistance").
0458.00
0458.01
This luminaire
contains built-in
LED lamps.
The lamps cannot be changed
in the luminaire.
WARNINGS FOR PROPERLY DISPOSING OF THE PRODUCT, IN COMPLIANCE WITH EUROPEAN
DIRECTIVE 2002/96/EC.
CAUTION: THE PRODUCT CONTAINS A LITHIUM BATTERY
At the end of its effective life, the product must not be disposed together with urban waste.
EN
13