Entering Bar Code Data - Brother P-touch 1400 Mode D'emploi

Entering bar code data

Press c.
1
2
Type in the new bar code data or edit the old data.
Press n to add the bar code to the text.
3
☞ To add special characters to the bar code data (only with protocols CODE39,
CODABAR, EAN128 or CODE128), position the cursor below the character
immediately to the right of where you wish to add the special character, and then
s
press . Press
n
then press
of the special characters that are available.)
☞ To change the data or WIDTH or UNDER# parameter settings of a bar code that has
already been added to the text, position the cursor below the bar code mark (
g
then press
☞ If the tape is to small the P-touch will automatically adjust the bar codes to prevent
the misreading or unreading by bar code reader.
The following special characters can only be added to bar codes created using protocol
CODE39 or CODABAR.
Symbol Character
–
0
1 .
2 (SPACE)
3 $
20
u d
or
to add the character to the data. (Refer to the tables below for a list
c
, then .
CODE39
Symbol Character
4
5
6
until the desired special character is displayed, and
Symbol
/ 0
+ 1
% 2
CODABAR
Character Symbol
–
3
$ 4
: 5
), and
Character
/
.
+