On A Wall; Wall-Mounting Instructions - Paradigm Soundscape Manuel De L'utilisateur

PLACEMENT

ON A WALL

ACTION REQUIRED: When
mounting Soundcsape on a
wall for best results, adjust the
unit's equalization and voicing
to make sure you are achieving
the best sound for the location.
Remove feet, if desired, before
wall mounting.
Use the Soundscape's internal
menu system to choose:
INSTAL > ON WALL.
What's included
1 x Wall-Mounting Bracket and 2 x Levelling Screws
Tools recommended (not included)
1 x Stud Finder
1 x Level
1 x Electric drill and appropriate drill bits

Wall-Mounting Instructions

Follow the directions below and use the illustrations (Figs. 2 – 8)
provided on the following pages for guidance.
1 Decide on mounting location and use a level to make sure
Soundscape's Wall-Mounting bracket sits level (Fig. 2).
2 Mark the three center pilot hole screw locations (Fig. 3).
3
Use a stud finder to determine if there is a stud behind
one of the three center screw locations (not shown).
If a stud is found drill a pilot hole. If no stud is found
use the centermost screw location and drill a pilot hole
for a wall anchor. Install wall anchor (not shown).
4 Using a screw, attach the bracket to the wall. DO NOT
tighten the screw at this point (Fig. 4).
5
Use a stud finder to determine if a stud lies behind any of
the left and right screw locations. If a stud is found the
top and bottom screw holes with a stud behind them are
EN-7
your screw locations. If no stud is found use the top
Cont'd
Paradigm does NOT supply
screws and anchor bolts to mount
Soundscape to a wall. Choose screws
and anchor bolts appropriate for size
and weight of Soundscape.
Dimensions of Soundscape (H x W x D):
5-1/2˝ x 42˝ x 5˝ / 14 cm x 106.7 x 12.7 cm.
Weight of Soundscape:
20 lb / 9.1 kg
We provide limited instructions for wall
mounting, please contact your Paradigm
Dealer for more detailed information.
Hardware (not included)
5 x Screws appropriate to mounting surface
and weight of Soundscape.
5 x Wall anchors appropriate to mounting surface
and weight of Soundscape.
and bottom centermost screw locations as your screw
locations. Use a level to square the bracket and mark the
remaining pilot hole locations (Fig. 5) .
6
Remove the wall bracket or pivot bracket to allow access
to the remaining screw locations. a) If a stud is found,
drill pilot holes. b) If no stud is found drill pilot holes
and install wall anchors.
7
Using the screws, attach the wall bracket to the wall.
DO NOT fully tighten (Fig. 6).
8 Use a level to square the bracket, then tighten all screws
(Fig. 7).
9
Attach audio and power cables. Refer to 'CONNECTION'
section of this manual for more information.
10 Move Soundscape into place. Drop the shoulder bolts
into the wall bracket keyholes (Fig. 8). Before releasing,
make sure the Soundscape has dropped fully into the
keyholes and is rmly in place (Fig. 8 Inset).
The instructions that
follow assume the
mounting surface
is drywall with
standard wood studs. Should
you wish to mount to another
type of surface please consult
a certi ed contractor or your
Paradigm Dealer before you
begin the installation.