Publicité
Les langues disponibles
Les langues disponibles
(24) Front stabiliser bar with wheels;
(99) Rear stabiliser bar with adjustable
feet; (101) Saddle; (45L) Left pedal;
(45R) Right pedal; (133) Slot head bolt
M-10; (134) Flat washer M-10; Double
ended spanner.
2. Position the machine's rear stand
on the rear stabiliser bar (99), as
shown in Fig.2, insert the bolts (133),
fit the flat washers (134) and then
tighten securely.
3. Position the front stabiliser bar with
wheels (24), paying attention to the
red dots and with the wheels facing
forwards, as shown in Fig.2, insert the
bolts (133), fit the flat washers (134)
and tighten securely.
4.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal, marked with the
letter (45R), screws onto the right-hand
crank, also marked with an (R), in a
clockwise direction. Tighten securely,
Fig.3.
The left-hand pedal, marked with the
letter (45L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.3.
5.- ATTACHING THE SADDLE.-
Fit the saddle bracket (101), Fig.3, onto
the horizontal saddle tube (3), as
shown in Fig.3, fit the saddle into
position and tighten the nuts on the
bracket securely.
direction.
Tighten
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob
(75)
anticlockwise, Fig.3, move the saddle
to a position comfortable for doing
exercise
and
adjustment knob (75) securely by
turning it clockwise.
HORIZONTAL ADJUSTMENT OF
THE SADDLE.-
Loosen the knob (106) slightly by
turning it anticlockwise, Fig.3, move
the saddle to a position comfortable
for doing exercise and then tighten the
knob (106) securely by turning it
clockwise.
6.- FITTING THE MONITOR.-
Position the handlebar (4) on the
handlebar stem (3), Fig.4, tighten the
knob (5). Take the monitor (1) and
remove the four screws (2) from the
base of the monitor, Fig.5. Place the
monitor (1) in the direction of the
arrow sliding the monitor on the
holding plate.
Connect the terminal (11) in terminal
of the rear part of the monitor (1)
Fig.4, and attach it using the four
screws (2) removed previously.
Once the monitor is assembled attach
the cover (16) as shown in Fig.6.
7.- FITTING THE HANDLEBAR.-
Insert the handlebar stem (3) into the
hole on the main body (69), Fig.7.
Position it correctly and then tighten
knob (75-79) by turning it clockwise.
Plug connector (11), coming out of the
main post (3), into connector (89),
coming out of the boss on the main
body (69) Fig.8. Place the cap (15)
and secure with screws (13).
10
slightly
by
turning
then
tighten
it
the
Publicité
