Possible Foreseeable Misuse; Residual Risks; Symbols On The Appliance; Product Overview (01) - AL-KO CT400 Mode D'emploi

GB
Observe the following values when working with
the trailer:
■
The maximum payload of the CT400 on level
ground is 400 kg.
■
The maximum payload of the CT400 for up-
hill and down-hill operation (18%/10°) is
200 kg.
■
The maximum speed of the trailer is 5 km/h.
This trailer is intended solely for use in non-com-
mercial applications. Any other use as well as un-
authorised conversions or modifications are re-
garded as contrary to the intended use and will
result in voiding of the warranty as well as loss of
conformity; the manufacturer will thus decline any
responsibility for damage and/or injury suffered
by the user or third parties.
2.2

Possible foreseeable misuse

The tool is designed neither for commercial use
in public parks and sports facilities, nor for use in
farming and forestry.
The trailer is not approved for use on public
roads.
The trailer is not designed for the transport of
persons.
2.3

Residual risks

Even during correct use of the appliance, there is
always a certain residual risk that cannot be ex-
cluded. Depending on the use, the following po-
tential risks can be derived from the type and
construction of the appliance:
■
In sharp curves, the trailer can collide with
the tractor.
2.4

Symbols on the appliance

Symbol Meaning
Pay special attention when handling
this product!
Read the operating instructions be-
fore starting operation!
Passengers must not be transport-
ed with the trailer.
16
Symbol Meaning
Maximum 5 km/h
When parking the trailer, secure it
to prevent it from rolling away and
to prevent unauthorised use.
Max. payload on level ground
400 kg
Max. payload for up-hill and down-
hill operation 200 kg
Wear protective gloves during as-
sembly and hitching.
2.5 Product overview (01)
No. Component (number)
1 Tray (1x)
2 Support plate under the skip (2x)
3 Wheel 650-8 (2x)
4 Wheel axle (1x)
5 Drawbar (preassembled)
6 Lever
7 Foot
8 Handle
2.6

Scope of supply (02)

The items listed here are included in the standard
scope of supply. Check that all items are present:
No. Component
1 M10x25 mm bolt, nut and washer kit
(10x)
2 M8x20 mm bolt, nut and washer kit (8x)
3 M8x50 mm bolt, nut and washer kit (4x)
4 M8x60 mm bolt, nut and spacer kit (2x)
5 Handle connector (2x)
Product description
CT400