Samsung DVD-1080P9 Manuel D'utilisation page 10

getting started
Rear Panel
1. AUDIO OUT JACKS
- Use audio cables to connect to the Audio input jacks
of your television or audio/video receiver
2. DIGITAL AUDIO JACKS
- Use either an coaxial digital cable to connect to a
compatible Dolby Digital receiver.
- Use either an coaxial digital cable to connect to an A/V
Amplifier that contains a Dolby Digital, MPEG2 or DTS
decoder.
3. VIDEO OUT JACK
- Use a video cable to connect to the Video input jack
on your television.
Note
- Consult your TV User's Manual to find out if your TV supports Progressive Scan (P-SCAN).
If Progressive Scan is supported, follow the TV User's Manual regarding Progressive Scan settings in the
TV's menu system.
- The HDMI output of this unit can be connected to a DVI jack on a TV or other device using a conversion
adapter. In this case, it is necessary to use a TV or display with an HDCP-compatible DVI input.
- Refer to the TV's instruction manual for detailed information regarding the TV's HDMI input jack.
- See pages 51~ 52 to get more information on how to use the setup menu.
10_ getting started
1
2
4
3
4. COMPONENT VIDEO OUT JACKS
- Use these jacks if you have a TV with Component
- If
- If
5. HDMI OUT JACK
- Use an HDMI cable to connect this jack to the HDMI
- If an HDMI cable is connected to an HDMI-compatible
5
Video in jacks. These jacks provide P
video.
P-SCAN
is set to "ON" in Video Output of the
Setup Menu, progressive scan mode will work.
I-SCAN
is set to "ON" in Video Output of the Setup
Menu, interlaced scan mode will work.
jack on your television for the best quality picture.
TV, HDMI will be output automatically from the player
about 10 seconds later.
, P and Y
R B