Using Your Ceramic Hob - amzchef YL-CT5401 Manuel D'instructions

Make sure that the base of your pan is smooth, sits flat against the glass, and is the same
size as the cooking zone. Always centre your pan on the cooking zone.
Always lift pans off the ceramic hob – do not slide, or they may scratch the glass.

Using your Ceramic Hob

To start cooking
• After power on, the buzzer beeps once, all the indicators light up for 1 second then go out,
indicating that the ceramic hob has entered the state of standby mode.
1. Touch the ON/OFF
indicating that the ceramic hob has entered the state of standby mode.
2. Place a suitable pan on the cooking zone that you wish to use.
• Make sure the bottom of the pan and the surface
of the cooking zone are clean and dry.
3. Touching the heating zone selection control, and a indicator next to
the key will flash.
4. Select a heat setting by touching the "-" or "+" control.
• If you don't choose a heat setting within 1 minute, the ceramic hob will
automatically switch off. You will need to start again at step 1.
• You can modify the heat setting at any time during cooking.
• By holding down either of these buttons, the value will adjust up
or down.
control，all the indicators show "-" or "- -",
12