Renault Radio Connect R & GO Mode D'emploi page 95

R & GO: GENERAL DESCRIPTION
76 77 78
79
80
Telephone holder
To attach the telephone holder 79 onto
your vehicle's audio system, follow
these instructions:
– remove the telephone bracket's
cover 23 by turning counter-clock-
wise to expose the USB2 socket;
– set the arrow 77 of the locking
knob 76 in the up position before
putting the phone holder 79 on the
audio system for correct connection;
(5/6)
– connect the telephone holder 79 to
80
the audio system's USB2 socket;
– turn the locking knob 76 of the phone
holder 79 clockwise to secure it;
– place your phone in the telephone
holder 79 and press both clips 80
until the phone is firmly held in place.
To remove the telephone holder 79
from your audio system:
– hold your phone while pressing the
retaining clips 78, then take out your
phone;
– turn the locking knob 76 of the phone
holder 79 anticlockwise to release it
from your vehicle's audio system;
– disconnect the telephone holder 79
from your vehicle's audio system;
– replace the telephone holder 23
cover by turning it clockwise to close
the USB2 socket.
GB.37