JVC Exad KW-AVX820 Manuel D'instructions page 20

Sound
Menu item
Fader/Balance
Fader/Balance
Reset
Fader
Balance 0
Back
Volume Adjust * 1
Subwoofer Level
High Pass Filter
Crossover
Amplifier Gain * 2
3
Rear Speaker *
* 1
For "DISC/USB": You can make the adjustments separately depending on the audio format—Dolby digital/MPEG
Audio and the others.
* 2
The volume level automatically changes to "VOL 30" if you change to <Low> with the volume level set higher than
"VOL 30."
* 3
This setting takes effect only when Dual Zone is activated. (
20
Fader : Adjust the front and rear speaker output balance.
♦
F6 to R6; Initial 0
0
• When using a two-speaker system, set the fader to the center (0).
Balance : Adjust the left and right speaker output balance.
♦
L6 to R6; Initial 0
5 ∞ 2 3
Press [ / / /
Adjust and store the auto-adjustment volume level for each source, comparing
to the FM volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix> appears if an FM broadcast is selected as the source.
♦
–12 to +12; Initial 00
Adjust the subwoofer output level.
♦
–06 to +08; Initial 00
♦
Through : Select when the subwoofer is not connected.
♦
On : Select when the subwoofer is connected.
Select the crossover frequency between the front/rear speakers and the
subwoofer.
♦
80Hz, 120Hz, 150Hz
You can change the maximum volume level of this unit.
♦
Off : Deactivates the built-in amplifier.
♦
Low : VOL 00 to 30 (Select this if the maximum power of the
♦
High : VOL 00 to 50
You can activate/deactivate the rear speakers.
♦
On : Activate the rear speakers.
♦
Off : Deactivate the rear speakers.
Selectable setting/item
] or drag [ ] to adjust.
speakers is less than 50 W.)
40)
Initial: Underlined