Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10-16x
2. COMPONENTS
2.1. Basic components
1. camera
2. loudspeaker
3. opening for key
4. service set connector
5. microphone
6. nameplate
7. potentiometers for volume adjustment of the microphone and loudspeaker
8. connection terminals
9. cable inlet
10. holes for wall mounting
11. metal protective cap
12. clamping springs for fixing the nameplate
13. namecard
14. infrared LEDs
15. light sensor
16. connection point for nameplate lighting
17. lighting element for nameplate
18. serial number
19. selection switch for six-wire/five-wire cabling
20. connector for nameplate lighting
21. bell push button
2.2. Additional accessoires
The external video unit is connected using six-wire cabling. Use a twisted cable for optimal video
image quality. Also pay attention to the diameter of the wires in the cable, as this determines the
maximum distance that can be covered between the power supply and the external video unit.
Niko recommends using the following cables to install the external video unit:
• JYSTY (-F2) min. 3 x 2 x 0.8 mm (max. distance 200 m)
• TVVF (-F2) min. 3 x 2 x 0.8 mm (max. distance 200 m)
• TPVF min. 3 x 2 x 0.6 mm (max. distance 100 m)
• UTP/FTP/STP 4 x 2 x 0.5 mm (max. distance 70 m)
Function of the wires to be connected:
• terminals a and b: communication bus (24 Vdc)
• terminals V1 and V2: video signal
• terminals P and M: extra power supply (26 Vdc)
3. INSTALLATION
3.1. Mounting and connecting the external video unit
Attention: Disconnect all power before installing the external video unit. Do not connect the device
to the power supply voltage until installation is completed.
26
EN
Publicité
Table des Matières
