Programming - S&P CTB ECOWATT Instructions De Montage Et D'utilisation

4. Line up electronic component TIMER RTC ECOWATT with J4 connector pins
5. Fit the accessory pressing down

7.2. PROGRAMMING

During programming process must defi ne following parameters:
• T1, T2, T3: Start time for each period frame (OFF,00:00-23:59).
• Period T1, Period T2, Period T3: Minutes of each time period related to start time defi ned (until 480 minutes).
• Set point T1, Set point T2, Set point T3: Set point in % during period frame over operation mode previously selected (e.g. if
PI PRESSURE+RTC mode is selected and set point T1 is 50%, during period frame the fan will reduce the speed accordingly
with a minus 50% of the pressure set point defi ned).
Example:
MONDAY
1:00
2:00
3:00
T3 = 480 min
4:00
SetpointT3 = 25%
5:00
6:00
7:00
8:00
9:00
T1 = 60min
10:00
SetpointT1 = 50%
11:00
12:00
13:00
14:00
T2 = 120 min
SetpointT1 = 50%
15:00
16:00
22:00
23:00
T3 = 480 min
SetpointT3 = 25%
0:00
TUESDAY ...
T3 = 480 min
SetpointT3 = 25%
T1 = 60min
SetpointT1 = 50%
T2 = 120 min
SetpointT1 = 50%
T3 = 480 min
SetpointT3 = 25%
53
SATURDAY
T3 = 480 min T3 = 480 min
SetpointT3 = 25% SetpointT3 = 25%
T1 = 60min
SetpointT1 = 50% SetpointT1 = 50%
T2 = 120 min T2 = 120 min
SetpointT1 = 50% SetpointT1 = 50%
T3 = 480 min T3 = 480 min
SetpointT3 = 25% SetpointT3 = 25%
SUNDAY
T1 = 60min